rudy
New Member
Posts: 49
|
Post by rudy on Feb 19, 2021 10:56:37 GMT
what is when i transmitt on a dmr repeater in BLACK screen the " BS failed " 
PS when activated the "promiscus mode" what is the icon on the display ?
|
|
eb3bkw
Junior Member
Posts: 70
|
Post by eb3bkw on Feb 19, 2021 19:28:44 GMT
Base Station not response. That means that you do not have the repeater in coverage, or that you do not access it due to an error in the programming of your codeplug
|
|
|
|
Post by willywoe on Feb 20, 2021 11:35:45 GMT
Hmmmm in my case it meant "Band Split" failed. Any difference + or - between the TX and RX frequencies inhibited the TX. I have never found a solution for this problem, so the radio now sits sulking in it's box. Good luck.
|
|
|
|
Post by bosley on Mar 4, 2021 13:55:27 GMT
Or you can RECEIVE the repeater but repeater CANNOT HEAR your transmission on analog you might hear noise on digital you basically work or dont work so you may need more power a better antenna or both - I get this (BS fail) with a repeater thats about 25 miles away from me - so use that repeater as an antenna test myself - Yagis apparently do work.
|
|
|
|
Post by David M0DMP on Apr 20, 2021 2:45:42 GMT
Hmmmm in my case it meant "Band Split" failed. Any difference + or - between the TX and RX frequencies inhibited the TX. I have never found a solution for this problem, so the radio now sits sulking in it's box. Good luck. That's easy. It's not Band Split failed. If you are using DMR with a frequency split - ie through a repeater or dual-ts hotspot, the radio and the repeater need to sync, so the radio can drop into the correct time slot fot TX. The repeater is not correctly syncing with you (wrong colour code, wrong freq, out of range), so the radio won't tx. If it's simplex, there is no sync process (as it isn't duplex), so this issue doesnt happen. David |
|
